More Work on the Rear

Another couple of hours on the car advanced the rear. No pictures because it's not quite visible.

Jacked the car up and riveted the rear panel to the chassis. Used 4 rivets under, two on the sides also under and two nearer the top against the chassis rail where the upper side of the coils fit.

Then used a bit of old wire and crimped an extension to the fog light wire. Connected it to the light pod and closed it. Just forgot to cable-tie the wire to the chassis, will have to do it next time.

Last job was to drill and fit the filler cap. This took a bit more work because the bolts were 4mm in diameter and I only had 3,5 and then a 4,75 drillbits. So I drilled with the 3,5mm and then used a file on the fiberglass to enlarge the holes to fit. Some time later, the fuel cap was in, bolted to the fiberglass and the ties on the hose also tightened.

Also removed the battery from the car and charged it in preparation for a drive soon.

Next session will be the buttons for the cover and then start on the rear wheel arches.